Twisted Sick Robotics

[Koolaid64]

it added about 7/16" to the dia of the plastic. it all depends on the tire you pick out though. I wanted yellow though so I just grabbed something cheap off of amazon. the contact adhesive I used is called Dap. I'm not sure how well it will do with the UHMW but I think its the best non specialized option. 

Kyle

[Koolaid64]

I have been pretty busy working on the bot over the last week. I squared up all of my frame bits and then located and drilled all of my holes. My pretendo bot was getting pretty strong now. I then shaped the reliefs for the wheels in the outside rails. The drive pods are looking very good and feeling very strong. I also sharpened the axe. I'm pretty much at the point where all I have to do is make the top and bottom plates and wire the thing.




-Kyle

[zacodonnell]

It's looking really mean. Are the frame rails .25" 6061? With the standoffs I'll bet it is really stiff and solid when you tighten it all down. Mine is like a bowl of spaghetti in comparison

-Zac

[Koolaid64]

Yup .25 6061. It's very brick feeling with the top and bottom plates on it. All I have left is to wire it.


-Kyle